Direct Feed Systems

Our Rainwater Harvesting Direct Feed System is designed for the home owner to collect, filter and store rainwater within an underground tank for both domestic and garden irrigation purposes.

In this system, water is fed directly from the submersible pump in the underground tank to each appliance.

Due to the submersible pump featuring pressure sensitivity, whenever a toilet is flushed, the pump will register a drop in pressure, then pump until the cistern is full and automatically switch itself off again.

Rainwater is classed as non-potable, allowing water to be used for toilets and washing machines.

Together with garden use which can be more than you’d expect, this equates to around 50% off your incoming mains water.

What happens if it doesn't rain?

Should the rainwater tank ever run dry in drought periods, the system is provided with a mains water backup – the Rain Backup in a Box®.

The system uses a level sensor in the tank to open a solenoid valve within the control unit to allow around 200L of mains water to enter the underground tank.

The mains water back up device used in our direct feed system is designed to deliver a small amount of mains water to ensure all domestic appliances are kept fully functioning during times when the underground rainwater tank has insufficient water due to lack of rain fall.

Read more about the Backup in a Box by Clicking Here.

What is in a Direct Feed System

In our standard Shallow Dig F-Line Garden System are the following components. We try to make sure that you have everything required apart from the underground 110mm drainage pipe.

  • Underground Storage Tank
  • Tank Shaft
  • Pedestrian Lid or vehicle loading shaft
  • Submersible Pump
  • Filter, Calmed Inlet and Overflow Siphon
  • 25m x 25mm RWH HDPE Pipe
  • Rainwater label Pack
  • Mains water backup ( Backup in a Box )